Loading... Please wait...| Housing: | Hammered copper roof with hemmed edge and copper stem. ½" NPS male threads to screw onto accessory mounting stake or junction box, sold separately. |
| Finish: | Antique Copper (AC) is a hand-applied dark copper patina. |
| Optical Assembly: | Frosted tempered glass sprinkler shield includes top and bottom silicone gaskets for tight seal. |
| Lamping: | 10W maximum T3 bi-pin lamp. Lamp is included with fixture. Lower wattage lamps are acceptable. |
| Electrical Assembly: | Bi-pin socket type (G4) with 250° C high temperature teflon coated wire leads. 12 Volt fixture is pre-wired with 3-ft pigtail of 18-2 AWG, 105° C, SPT-1W wire. Low voltage quick connector, catalog #LVC3 included for easy hook-up to the low voltage supply cable, not included. 12 Volt system requires remote transformer, not included. |
| Warranty: | Ten-year limited warranty. |
| Certifications: | ETL listed to U.S. safety standards for wet locations. cETL listed to Canadian safety standards for wet locations. Manufactured to ISO 9001:2008 Standards. |
| Height: | 11 7/8" (302mm) |
| Width: | 5 1/2" (140mm) |
| Max. Weight: | 1.85 lb. |
Posted by Unknown on 19th Aug 2012
This is a nice quality light made of copper. They say it is hand hammered, but I got two, and the indentations all look the same. Hmm. Also, the light socket in the one is a little loose which caused the light to go out. I had to bend one bulb wire to make it fit tighter. I would recommend this light even though it is a bit pricey.