The revolutionary i1.5 composite inground provides optimum performance in a small aperture luminaire. Patented design elements including a hinged lens ring, potted factory seal, cool lens option and only 2 screws that do not require a torque wrench - the i1.5 reinforces HADCO's position as the leader in landscape lighting.
|Housing||Single-piece compression molded fiberglass reinforced polyester composite, factory pressure tested to ensure water will not wick or leak through. Separate compartments provide isolation between field wiring, optics, and ballast. Isolated, grade-mounted sealed wiring compartment with two (2) 3/4" threaded conduit inlets in bottom for feed-through wiring capabilities and supplied with gel-filled wire nuts. Cast cover to match lens ring with two captive stainless steel slotted Phillips machine screws for access. Potted factory seal with anti-wicking wiring between grade-level junction compartment and ballast compartment. Isolated ballast compartment with key-slotted cover. Half dome 360 degree field adjustable for glare control, constructed of natural cast bronze (natural finish) or cast stainless steel (satin finish) to match lens ring. Lens ring is hinged with two captive stainless slotted Phillips machine screws for access to lamping compartment (tamper-resistant screws available upon request.) Lens ring and rockguard accessories are available in natural cast bronze or cast stainless steel. Both options are designed to mount utilizing factory pre-drilled holes on lens ring with water channel to allow lens to stay free of dirt and contamination build-up.||Finish||Natural Bronze has satin matte finish, will age over time. Composite is pressure formed, molded-in color (black). Stainless Steel has satin matte finish.||Lamping||Lamp is included with fixture. (12V) 12W Par 30 Short EnduraLED lamp, 10W MR16 (Bi-Pin) EnduraLED lamp. Lower wattage lamps are acceptable.||Optical Assembly||Aiming 15° either side of vertical and full 360° rotation. Angle degree marks for precise vertical aiming with tool-less aiming. Clear, slightly convexed, molded borosilicate glass, high impact, 3000 lb. live load rated, drive-over glass, with molded wrap around 100% silicone lens gasket. Handle enables easy tool-less removal of optical Assembly for hot aiming and re-lamping, simply press-fit back into place.||Electrical Assembly||4kv rated porcelain medium base with nickel-plated screw shell with center contact, 12W PAR30. Bi-pin socket type (GU5.3) with 250° C high temperature teflon coated wire leads, 10W MR16.||Warranty||Ten-year limited warranty.||Certifications||Manufactured to ISO 9001: 2008 Standards. ETL listed to U.S. safety standards for wet locations. cETL listed to Canadian safety standards for wet locations. ADA compliant when used in concrete and flush mounted with CPS15.||Width||7 1/2" (191mm)||Depth||9 3/4" (248mm)||Height||6" (153mm)||Wattage||LED10 10W MR16, LED12 12W PAR30S||CCT||W Warm, C Cool||Optics||FL Flood, SP Spot||Ip Rating||IP66/68: Dust-tight and dual rated - sealed against direct jets of water and against continuous submersion in water tested to 1 meter (3.28 feet).||Voltage||120 120 Volts, 277 277 Volts|